Installing a Golf Cup in Artificial Turf
Quick answer
To install a golf cup in artificial turf, mark the location, cut a clean hole in the turf, excavate the base to the cup's depth plus room for drainage, set the cup level and flush with the base, backfill and compact around it, then trim and secure the turf edge to the cup lip. Run any wiring before closing the base.
Before you start
- Read the cup and fixture manufacturer's instructions — they take priority over this general guide.
- Call 811 to locate underground utilities before digging.
- Plan your wiring route from the cup to the power source.
General installation steps
- Mark the cup center and the outline of the cup on the turf.
- Cut the turf carefully along the outline with a sharp blade, cutting from the backing side where possible for a clean edge.
- Excavate the base to the depth the cup requires, plus space for a drainage layer beneath it.
- Add drainage material at the bottom so water can leave the cup.
- Set the cup so its rim is level and flush with the finished base surface.
- Route wiring to the fixture position per the fixture instructions, leaving slack for service.
- Backfill around the cup in layers and compact firmly so it cannot shift.
- Lay the turf back, trim it to meet the cup lip neatly, and secure the edge.
- Install the LED fixture, flagstick and flag, then test before infilling.
Common mistakes
- Setting the cup slightly high, which makes balls bounce out.
- Skipping drainage, leaving water standing in the cup.
- Loose backfill that lets the cup tilt over time.
Safety
Safety: follow the fixture manufacturer's instructions, call 811 before digging, and have low-voltage wiring connections made by a qualified person where local code requires it.
Light your backyard green.
Cup, LED fixture, wiring, drainage hardware, flagstick and flag in one kit. Packages of 1, 3, 4 or 6.
See the LED Golf Cup Light KitRelated guides
General information only. Always follow the instructions supplied with your products and local codes.